 |
Temperature Indicators, Controllers
& Transmitters
Product Selection Guide
|
Digital temperature
meters and temperature controllers
are available from Laurel Electronics fully configured for all
common thermocouple types and for DIN or ANSI RTDs. With Laureate
digital panel meters, an optional isolated analog output scaled to
the display can turn the meter into an isolated, high-accuracy,
linearizing 4-20 mA or 0-10 V or transmitter. Optional relays and
multiple programmable setpoint control modes turn the meter into a
flexible ON/OFF temperature controller. |
 |
|
|
|
Laureate Temperature
Panel Meter |
High-accuracy digital panel meter for all popular thermocouple types (J,
K, T, E, N, S, R) and 100-ohm platinum RTDs (DIN or ANSI). The
thermocouple or RTD type, range and resolution (1° or 0.1°), and unit of
measure (°F or °C) are user-selectable. Built-in excitation for RTDs
with 2, 3 or 4-wire hookup. An optional isolated analog output scaled to
the display can turn the meter into an isolated, linearizing 0-10 V or
4-20 mA transmitter. Optional data I/O and relays for alarm or control.
Five 0.56" (14.2 mm) high digits, 1/8 DIN case.
|
|
|
Temperature Transmitter,
0-10V or 4-20 mA Analog Output |
Same signal conditioner Laureate Panel Meter
for all popular thermocouple types
(J, K, T, E, N, S, R) and 100-ohm platinum RTDs (DIN or ANSI). Highly
accurate, linearized, stable and repeatable transmitter output
selectable as 0-10V, 4-20 mA or 0-20 mA. The temperature range can be as wide as the entire span
of the thermocouple or RTD type, or as narrow as 150 counts (such as
15.0°). RS232 or RS485 are jumper selectable. Dual relays optional for alarm or control.
|
 |
|
Temperature Transmitter,
Modbus or Laurel ASCII Serial Output |
|
Same signal conditioner Laureate Panel Meter
for all popular thermocouple types (J, K, T, E, N, S, R) and 100-ohm
platinum RTDs (DIN or ANSI). Transmitter output can be via
RS232 or RS485, which are jumper selectable and can each be
associated with either the Modbus protocol or Laurel’s simpler Laurel
ASCII protocol. Modbus operation is fully compliant with the Modbus Over
Serial Line Specification V1.0
(2002) for 2-wire, half-duplex
connection.
Dual
relays optional for alarm or control. |
|
|
